EN 10025:3 S460N Steel

The plates can be supplied straight from stock, cut to size, or profiled to specific shapes.
The specification EN 10025:3 covers weldable structural steels manufactured with a fine grain structure and supplied in the normalised condition or in an equivalent condition obtained by normalised rolling.

About EN 10025:3 S460N Steel Plate
The specification EN 10025:3 covers weldable structural steels manufactured with a fine grain structure and supplied in the normalised condition or in an equivalent condition obtained by normalised rolling. There are four grades of EN10025:3 steel plate, (S275, S355, S420 and S460) these indicate each grade’s minimum yield strength (in MPa) for plates 16 mm thick and below. Each grade is further sub-divided based on the specified minimum value of impact energy at a particular temperature. N indicates temperatures not lower than -20 deg C and NL not lower than -50 deg C.
The designation EN 10025:3 S460N shows that this is steel for structural purposes (S) with minimum yield strength of 460 MPa (460) which is impact tested at -20 deg C (N).
As well as S460N we are stockists of plates to EN 10025:3 S460NL.

Requirements

(cast analysis, % by mass, maximum permitted unless indicated otherwise)

Product Thickness	Yield Strength MPa	Tensile Strength MPa	Elongation A%*
up to 16 mm	460min	540 to 720	17min
16 to 40 mm	440min	540 to 720	17min
over40 to 63 mm	430min	540 to 720	17min
over 63 to 80 mm	410 min	540 to 720	17 min
over 80 to 100 mm	400min	540 to 720	17min
over 100 to 150 mm	380 min	530 to 710	17 min
over 150to 200 mm	370 min	530 to 710	17 min

-50 ^oC	-40^oC	-20^oC	-10^oC	0^oC	+20^oC
-	-	40J min	43 J min	47J min	55J min

-50^oC	-40^oC	-20^oC	-10^oC	0 ^oC	+20^oC
-	-	20 J min	24 J min	27J min	31J min